- This topic has 7 replies, 5 voices, and was last updated 13 years, 1 month ago by
.
-
Posts
-
-
If the Tach works, it's something on the circuit board causing the problem and sad to say you wll have to replace the panel, or get you a aftermarket Hour gauge and drill a hole in the dash to install it
Tommy
Affordable Tractor Sales
“Your Jinma Parts Superstore”
-
-
Follow up…………As I was removing the cluster from the tractor. I heard a rattling on the inside of the cluster. I opened the cluster, removed the tach/hour meter and found the capacitor had broken off and rattling around inside the cluster housing. The wires were too short to re-solder. I have a neighbor who is a retired instrumentation engineer that just happened to have a capacitor with the same markings. We soldered the replacement capacitor in place, reassembled the cluster and waa-laa we now have hour meter readings again. I don't know if anyone else has had this same problem, but if you have, you might try this repair.I have been told that one can purchase this capacitor at your local radio shack. Sure hope this helps someone else.
-
Well good for you, glad you got it going, I have heard of that happing but it is something to watch out for
Tommy
Affordable Tractor Sales Co.
“Your Jinma Parts Superstore”
-
-
I agree that mechanical fastening of some sort is in order. In my 27 years (has it been that long?) in engineering, I have seen many broken solder joints – solder joints are electrical connections, not mechanical, for the reason seen here.
As for RTV, many kinds are not suitable for electronic components, the outgassing can corrode things. Some are electronics safe, but it's not really advertised which are and which aren't. I'd go with hot glue.
-
You can use a dielectric epoxy to “pot” the circutry.
Potted circutry has been around for a long time and is very effective in harsh environments.
Account deleted.
-
- You must be logged in to reply to this topic.