oil change technique

Forum › Forums › Tractor Operation And Maintenance › oil change technique

Viewing 3 reply threads
  • Author
    Posts
    • July 3, 2012 at 4:32 pm #34839
      gabmuks
      Participant
        • Offline

        Actually I  don't think I have the correct engine oil capacity listed

        in my manual. Manual says 3.5 Litres.

        I have that in so far but nothing shows on dipstick.

        Does anyone know where to find engine oil capacity for this engine.

         

        I believe it is 3 cylinder Lai Dong KM385?

      • July 3, 2012 at 4:33 pm #34840
        Tinbender
        Participant
          • Offline

          I'm not sure either.hmmm Drain, fill and go!

        • July 3, 2012 at 5:41 pm #34841
          gabmuks
          Participant
            • Offline

            Thanks Tinbender

             

            Ended up somewhere between 4 and 5 quarts

            before it showed on the stick.

            Will check it again tomorrow.

          • July 4, 2012 at 9:08 am #34843
            DavidPrivett
            Participant
              • Offline

              I do not know if your engine has the same to me oddity .I can not get a good dipstick reading on a cold engine, if I just pull out the dipstick on a first pulling out.It will barely read on the stick.When I push it back in and read it the second time it reads where it should be. But I would go with the dipstick not what is in the book for sure.

          • Author
            Posts
          Viewing 3 reply threads
          • You must be logged in to reply to this topic.