Foton 354 where to fill the transfer case?

Forum › Forums › Tractor Operation And Maintenance › Foton 354 where to fill the transfer case?

Viewing 2 reply threads
  • Author
    Posts
    • May 19, 2015 at 5:03 pm #37807
      DavidPrivett
      Participant
        • Offline

        on my 504a foton there is a rubber grommet to the rear of the gear shifter about 2 1/2 inches in dia. take it out you will see the fill plug there,I can not remember if there is a oil level plug in the side of the trans. case or not. but I assume so.

      • May 20, 2015 at 12:23 pm #37810
        Daniel Eady
        Participant
          • Offline

          Thanks for the info,  so on mine there is a plate with 6 screws right under the steering wheel on the floor in front of where you sit.  this plate appeared to be right above the transfer case.  under the plate there is another plate with two bolts that when removed that there are two oval shaped holes and I can see the large rod that connects the clutch to the transmission that runs right under the two oval holes.  These tow oval holes do seem to be above the transfer case…  these could also rout into the transmission though I would think….  I just don't want to mix gear oil in with the transmission oil if that is the case…  if anyone has any insight that would be great!  Thanks again!

        • May 22, 2015 at 5:00 pm #37825
          DavidPrivett
          Participant
            • Offline

            I think you uncovered that adjuster link for the clutch ,you could stick some wire in there to the bottom see if there is oil but I would think it should be dry , I think your in the bell housing.

        • Author
          Posts
        Viewing 2 reply threads
        • You must be logged in to reply to this topic.