Jinma 254 Clutch (yes another clutch thread)

Forum › Forums › Tractor Operation And Maintenance › Jinma 254 Clutch (yes another clutch thread)

Viewing 7 reply threads
  • Author
    Posts
    • May 20, 2018 at 6:31 am #47902
      DavidPrivett
      Participant
        • Offline

        I think you are correct it needs a clutch as I was watching the video the pedal position when the tractor starts to move is almost fully released ,it should be engaging sooner. Does it have a 2 stage clutch and does the pto operate normally? You checked all the pedals roll pins right.

      • May 20, 2018 at 9:49 am #47903
        ljplum12
        Participant
          • Offline

          It does have a 2-stage clutch.  The PTO runs fine.  I had to max out the pedal adjustment.  What roll pins do you mean?

        • May 20, 2018 at 7:40 pm #47904
          DavidPrivett
          Participant
            • Offline

            some of these tractors that have a shuttle shifts seem bad about shearing a pins in the levers that change tractor directions but now that I think of it  that would not be in your case. But look at all the pedal connections to make sure, I think no two were made the same. What kinda tractor and hp is it anyway?

          • May 20, 2018 at 7:42 pm #47905
            DavidPrivett
            Participant
              • Offline

              never mind I see it now duh stupid me

            • May 27, 2018 at 9:16 pm #47910
              DavidPrivett
              Participant
                • Offline

                well have you had time to get into it yet? just curious

              • May 29, 2018 at 8:42 am #47911
                ljplum12
                Participant
                  • Offline

                  Unfortunately I don’t have the space to work on it inside and with the temps being 100+ for the next few weeks I didn’t want to tackle this, so I took it to someone to work on.  He’s got it but hasn’t split it yet.  I’ll update with his findings.

                • May 31, 2018 at 12:52 pm #47913
                  ljplum12
                  Participant
                    • Offline

                    Update is that the clutch was down to the rivets.  New one has been ordered and hopefully I’ll be operational again shortly.

                  • May 31, 2018 at 4:56 pm #47914
                    DavidPrivett
                    Participant
                      • Offline

                      remember the new clutch will  wear in and need to be readjusted, you can not set and forget

                  • Author
                    Posts
                  Viewing 7 reply threads
                  • You must be logged in to reply to this topic.