3 point system not holding

Forum › Forums › Tractor Troubleshooting › 3 point system not holding

Viewing 2 reply threads
  • Author
    Posts
    • June 25, 2011 at 12:32 am #32631
      Affordable
      Participant
        • Offline

        Sounds like your 3-point lift may need to be rebuilt,not hard to do and we have the kits in stock

         

        Tommy

        Affordable Tractor Sales

        “Your Jinma Parts Superstore”

        http://www.affordabletractorsalesco.com

      • June 25, 2011 at 8:55 am #32632
        jstephen21
        Participant
          • Offline

          Thanks Tommy,

          I went to the parts page and see the lift repair kit. I presume this is what you are referencing, right?

           

          Did I blow the this out trying to lift something too heavy?

           

          Do I have to drain the hydraulic fluid completely before tearing this down? Being under the seat, I thought I might get away with not doing that?

           

          Also, I have a Jinma BH that is just rusting sitting in the garage. The thing just never worked well, and I replaced the O-Rings on it twice, but they continued to fail. Any interest in it for parts?

           

          Can you recommend a better BH to replace it?

           

          Thanks

        • June 25, 2011 at 3:18 pm #32634
          Bob Rooks
          Participant
            • Offline

            jstephen21 wrote:

            “Can you recommend a better BH to replace it?”

            LiTW, Tomcat, Woods, Bradco, just to name a few. I replaced mine with a LiTW a couple of years ago and am very happy with it. The newer units will have a curved boom like excavators. Also, it may be that your relief valve is set too high if you keep blowing O-rings.

            Account deleted.

        • Author
          Posts
        Viewing 2 reply threads
        • You must be logged in to reply to this topic.