Blown 30amp fuse

Forum › Forums › Tractor Troubleshooting › Blown 30amp fuse

Viewing 7 reply threads
  • Author
    Posts
    • June 5, 2012 at 9:47 am #34693
      Tinbender
      Participant
        • Offline

        Check your safety switch the clutch pedal presses on, perhaps it's bent and shorting out.

      • June 5, 2012 at 9:59 am #34694
        1Jinma354
        Participant
          • Offline

          Thanks, I checked it and it appears ok.  The clutch, when pressed, closes the switch.  I will look for shorts when it stops raining.

        • June 5, 2012 at 3:32 pm #34696
          RichWaugh
          Participant
            • Offline

            My 304 Jinma did that same act and I puled the voltage regulator and lugged it back in which seemed to cure the problem.  Something else to try, at least.

          • June 7, 2012 at 8:06 am #34699
            1Jinma354
            Participant
              • Offline

              Thanks, I ordered a new starter for it.  In the meantime I'll try that.

            • June 8, 2012 at 8:35 am #34701
              Tinbender
              Participant
                • Offline

                Did you take the starter off and get it checked? Most part stores will do this for you. The reason I ask is that after reading these forums for a few years I would highly suspect the key switch.readin

              • June 8, 2012 at 9:20 am #34702
                1Jinma354
                Participant
                  • Offline

                  Haven't even looked at it.  Weather is finally clearing for the weekend.  It's been raning all week.  frown

                • June 8, 2012 at 9:28 am #34703
                  1Jinma354
                  Participant
                    • Offline

                    Thanks for your suggestion.  I ordered the switch just in case.

                  • June 11, 2012 at 10:33 am #34734
                    1Jinma354
                    Participant
                      • Offline

                      OK, first suggestion was best.  I changed started to no avail.  THEN I disconnected tie wraps on wiring harness and found a short to ground.

                       

                      Cleared the short and it started right up.

                       

                      Thanks guys

                  • Author
                    Posts
                  Viewing 7 reply threads
                  • You must be logged in to reply to this topic.