Clutch alignment tool

Forum › Forums › Tractor Operation And Maintenance › Clutch alignment tool

Viewing 1 reply thread
  • Author
    Posts
    • February 10, 2021 at 8:19 am #49555
      DavidPrivett
      Participant
        • Offline

        not that I am aware of, remember the clutch alignment tool just centers the clutch disc in the pressure plate and flywheel and then gets removed before trans. gets mounted and there should not be any slop in the input shaft for the trans. making it any harder than it is to get assembled. From the ones I have done tractors are easier to reassemble than cars ,parts are just heavier.

        • February 10, 2021 at 11:42 am #49556
          jonesgrove
          Participant
            • Offline

            I use the clutch alignment tool to line up the splines on the shaft to match the clutch disc but still can’t get to to pull closer than 1″.  Rotating the PTO shaft and/or the flywheel doesn’t seem to help.  What am I doing wrong?

        • February 10, 2021 at 7:08 pm #49557
          DavidPrivett
          Participant
            • Offline

            could you have the clutch disc reversed and may be the pilot bearing is not right, is the throw out bearing right these are guesses. can you tell where the interference is?

        • Author
          Posts
        Viewing 1 reply thread
        • You must be logged in to reply to this topic.