fel problem

Forum › Forums › Tractor Troubleshooting › fel problem

Viewing 4 reply threads
  • Author
    Posts
    • May 24, 2011 at 4:45 am #32399
      Affordable
      Participant
        • Offline

        The priority valve makes sure you have steering before anything else,so that could be your problem,follow your hydraulic lines it should leave the pump and go to the inlet of the loader valve, out of the loader valve to the priority valve, from the priority valve to the steering box and to the rear 3-point.You may need to get a gauge to confirm whats going on.I'm assuming your tractor has 1- hydraulic pump for everything

         

        Tommy

        Affordable Tractor Sales

        “Your Jinma Parts Sperstore”

        http://www.affordabletractorsalesco.com

      • May 24, 2011 at 9:03 am #32402
        ridgerider
        Participant
          • Offline

          Thanks Tommy,ya it only has one hydraulic pump and its mounted near the altenator at front of tractor ,lines are  routed the way you said,just wondering if i should take the divider off and check it out?

        • May 24, 2011 at 11:58 am #32403
          Affordable
          Participant
            • Offline

            You can take it off and try to clean it , if it does not work I keep them in stock

             

            Tommy

            Affordable Tractor Sales

            ” Your Jinma Parts Superstore”

            http://www.affordabletractorsalesco.com

          • May 25, 2011 at 12:32 am #32406
            ronjin
            Participant
              • Offline

              The first thing that I would do is to install a pressure gauge between the pump and the FEL valve to see what is going on.

              RonJ

              ronjin

            • May 26, 2011 at 12:38 am #32409
              ridgerider
              Participant
                • Offline

                Thanks for info,will try your suggestions.

            • Author
              Posts
            Viewing 4 reply threads
            • You must be logged in to reply to this topic.