- This topic has 2 replies, 2 voices, and was last updated 9 years, 9 months ago by
.
-
Posts
-
-
Youll wanna pick your loader up first then put those feet in. Then roll the bucket forward and set it down until the feet that you just put in touch the ground, basically you just wanna get all the weight of the loader on the bucket and those feet. Then go up to your front loader wings.. where that big bolt on the threads that hold the pin is at. Loosen that up and remove the pin. You may have to do a little prying. After those are out, go up to the front of the tractor and remove the two small pins that hold the front support on. After that your ready to take off the loader, use the bucket and lift cylinders to wiggle it around until it looks loose and will slide out. Then back your tractor our just a little bit, don't stretch the hydraulic lines that go to your loader valve. When your in a good spot to unplug the hydraulic lines shut er off and unplug them from the loader, plug them back into themselves. Your good to go!! Hopefully this helps. I can get you pictures if need be. Have a good day!
Trevor Nystrom
Keno Tractors
Parts Department
541-850-8193
866-363-8193
Tyler Nystrom
Keno Tractors
parts@kenotractors.com
866-363-8193
Phone hours: M-F 8am to 5:30pm PST Sat 9am to 1pm PST -
-
- You must be logged in to reply to this topic.