OK this is just crazy! Cluch occasionally sticks and will not disengage from flywheel!

It sounds like you bent the main clutch hub when stabbing the trans. into 

the clutches. I use two long bolts in the engine to help align trans. shalf

and maintain the mating surfaces plane parallel by measuring around the 

bellhousing to engine all the time while going together. If I am right you will

have to split tractor again, and replace main disk. http://www.ctoa.net/ctoa/wp-co…..eys/', '', '1');” src=”../../../ctoa/wp-content/forum-smileys/sick0020.gif” alt=”vomit” />Then have to do all the

clutch adjustments. I would recommend alignment tool!  

 Idahoan Don

They bent hub could be the problem, I have also seen the roll pin in the clutch fork break and cause these same problems.Sad to say you have to split the tractor again to find, fix either of these problems..

When you say youchecked the clutch adjustment and they were fine ? What is fine ?

Tommy

Affordable Tractor Sales

“Your Jinma Parts Superstore”

http://www.affordabletractorsalesco.com