PTO does not disengage fully

Forum › Forums › Tractor Operation And Maintenance › PTO does not disengage fully

Viewing 3 reply threads
  • Author
    Posts
    • July 6, 2012 at 3:31 pm #34854
      cnsJohn
      Participant
        • Offline

        OK.  Reading the forum further, I can tell the clutch does need adjusting.  Was anyone able to locate the clutch adjusting instruction?

      • July 6, 2012 at 9:59 pm #34859
        Tinbender
        Participant
          • Offline

          It used to be here before the nuclear meltdown awhile back, I have them in one of the manuals that came with the tractor somewherehmmm.

          However, either Ronald at Ranch Hand  Supply or Tommy at Affordable in the dealers link will help you. It may be on one of their websites, I'm not sure.

        • July 8, 2012 at 2:30 pm #34868
          oldfart2
          Participant
            • Offline

            Be sure to check the roll pin in the linkage where the shaft from the tranny connects to the arm from the clutch. They are known to shear.

          • July 9, 2012 at 6:16 pm #34873
            vangough
            Participant
              • Offline

              I would bet on the rollPin  I had the same problem  replace it then drive a smaller roll pin inside the one you install

          • Author
            Posts
          Viewing 3 reply threads
          • You must be logged in to reply to this topic.