Torque spec for suction banjo bolt?

Forum Forums Bulldozer & Excavator Operation and Maintenance Torque spec for suction banjo bolt?

Viewing 2 reply threads
  • Author
    Posts
    • #34773
      Bob Rooks
      Participant
        • Offline

        Grizz wrote:

        “Anyone know what the torque spec for the suction banjo bolt is? The big-daddy one at the tank. Is it closer to “hand tight plus a quarter turn” or “lean on it until you burst a blood vessel in your eye”. hmmm

        roflmaoroflmaoroflmao If you are referring to the large hex fitting that holds the suction strainer in the reservoir I would use about 70 – 75 ft. lbs. if you are using a fiber gasket on it. If you are referring to just the banjo bolt and using copper washers then 30 ft. lbs. should be adequate. Those torque values are approximately what I use.

         

        Oh, and Keno filled it with AW46 but the manual states AW32.  Any downside to keeping with the AW46?

        AW46 will be fine in your moderate Bay Area climate. Man, I miss that climate frown.

        Account deleted.

      • #34781
        Tinbender
        Participant
          • Offline

          Bob Rooks wrote: AW46 will be fine in your moderate Bay Area climate. Man, I miss that climate frown.

           

          Not that I miss Oakland that much but….. It was 80 yesterday and I finally put out the tomatoes I've had in 2 gallon pots in the greenhouse, it's supposed to be 34 tonight yell

        • #34784
          Little_Grizzly
          Participant
            • Offline

            It was 102 here on saturday and it's 77 today. yell Our tomatoes don't know what to do.

        Viewing 2 reply threads
        • You must be logged in to reply to this topic.