Forum Replies Created

Viewing 5 posts - 1 through 5 (of 5 total)

Author

Posts
February 14, 2015 at 9:53 am in reply to: Hello to all it`s Terry t yosemite tractor 306 dozer grinding feal #37498
Yosemitetractor
Participant
- Offline
Where do I get the splined bushing to fit the drive plate

on the flywheel?
January 21, 2015 at 11:00 am in reply to: Hello to all it`s Terry t yosemite tractor 306 dozer grinding feal #37457
Yosemitetractor
Participant
- Offline
Still cant post a pic but I did put a pick in the photo album called dozer
January 19, 2015 at 5:57 pm in reply to: Hello to all it`s Terry t yosemite tractor 306 dozer grinding feal #37452
Yosemitetractor
Participant
- Offline
Pic
January 19, 2015 at 3:32 pm in reply to: Hello to all it`s Terry t yosemite tractor 306 dozer grinding feal #37450
Yosemitetractor
Participant
- Offline
I do see wear on the 6 spline main shaft all ready where it slides in to the adaptor on the flywheel. Any idea if the new parts are a harder shaft? This dozer only has 200 hres on it.

Thanks

Terry
January 16, 2015 at 2:37 pm in reply to: Hello to all it`s Terry t yosemite tractor 306 dozer grinding feal #37440
Yosemitetractor
Participant
- Offline
I didn`t check the hyd pressure before I pulled it a part.

The input spline look fine no sigh of and distorison.

The piston gets pushed by hyd pressure in to the clutch pack either forward or backwards and those parts look fine.

The oil that came out kinda looks like AW46 but the customer has put other kinds of oil in there as he had leaks.

I`m going to mark all the hoses today so I can look in to the rear end and see what I can find back there.
Author

Posts

Viewing 5 posts - 1 through 5 (of 5 total)