Forum Replies Created

Viewing 10 posts - 1 through 10 (of 16 total)

1 2 →

Author

Posts
February 13, 2017 at 12:39 pm in reply to: Is this a Jinma tractor or what #46702
Dan Madison
Participant
- Offline
Tommy at Affordable Tractor and Circle G tractors will have parts and manuals.

Dan
December 16, 2016 at 6:32 pm in reply to: What brand is my tractor #46563
Dan Madison
Participant
- Offline
That looks like the emblem that was on a weifang tractor that I used to have.

Dan
October 27, 2015 at 2:01 am in reply to: NEW SITE FOR 2016 !! #45315
Dan Madison
Participant
- Offline
Is there any way to set the time zone?

Dan
October 26, 2015 at 10:41 pm in reply to: NEW SITE FOR 2016 !! #45308
Dan Madison
Participant
- Offline
Looking good here in Arkansas!!

Dan
October 15, 2015 at 7:30 pm in reply to: Where’s Bob? #38126
Dan Madison
Participant
- Offline
He is on Tractorbynet quite often. In the Chinese tractor forum.

Dan
July 20, 2015 at 8:34 pm in reply to: Tach not registering rpms rigt #37975
Dan Madison
Participant
- Offline
cranked the tractor today tach was working like it was supposed to, reading correctly. guess it just needed a little break in period

Dan
July 19, 2015 at 1:46 pm in reply to: Tach not registering rpms rigt #37966
Dan Madison
Participant
- Offline
The old one quit working. That's the way I put it in ,touched the flywheel then backed it off.

Dan
July 2, 2015 at 9:13 am in reply to: Anyone have Hal’s phone number? #37919
Dan Madison
Participant
- Offline
It's fixed now

Dan
November 28, 2014 at 11:15 am in reply to: loosing antifreeze #37363
Dan Madison
Participant
- Offline
Those engines have an o-ring on the cylinder sleeve that can laek also

Dan
August 29, 2014 at 10:00 am in reply to: Jinma 200 rotary cutter #37179
Dan Madison
Participant
- Offline
4 foot implements are about all the 200 will handle

Dan
Author

Posts

Viewing 10 posts - 1 through 10 (of 16 total)

1 2 →