Forum Replies Created

Viewing 6 posts - 1 through 6 (of 6 total)

Author

Posts
May 27, 2013 at 1:36 am in reply to: Alternator crossover #36102
shuswap
Participant
- Offline
Hi Bob
Thanks for the reply. If I use one of these Delcos, do I just hook up the positive (red wire) and ignore the other three ? Any idea what size pulley to use? Thanks for the help.

Tom
June 11, 2012 at 9:53 pm in reply to: splitting a Jinma 284 #34738
shuswap
Participant
- Offline
Tommy

I have completed splitting and putting back together my Jinma 284. It was as you said. All the bell housing bolts to the motor were loose. I cleaned them all and locktited them. I now no longer have an oil leak. Thanks for all the advice and help.

Tom
May 26, 2012 at 9:21 pm in reply to: oil leak #34657
shuswap
Participant
- Offline
Tommy

When I Split the tractor and rebolt the bell housing, do I have to replace the rear main seal? If I wanted to change it, do I have to drop the crank or can i just remove the seal and replace it. Thanks

Tom
May 24, 2012 at 10:55 pm in reply to: oil leak #34652
shuswap
Participant
- Offline
It appears that I will have to split my Jinma 284 in two and remove the flywheel. Does anyone have any tips,instructions or suggestions on how to go about this. Thanks.

Tom
May 24, 2012 at 10:47 pm in reply to: oil leak #34651
shuswap
Participant
- Offline
i can not get in. Is there another way you can send it to me? Thanks Tom
May 24, 2012 at 8:35 pm in reply to: oil leak #34649
shuswap
Participant
- Offline
Tommy

Thanks for the response.Is there anything special needed[ tools,jigs] to replace the rear main seal and is there any tricks I should know?

Thanks Tom
Author

Posts

Viewing 6 posts - 1 through 6 (of 6 total)