Foton 404 4cyl oil pressure drop

Forum › Forums › Tractor Troubleshooting › Foton 404 4cyl oil pressure drop

Viewing 6 reply threads
  • Author
    Posts
    • May 16, 2023 at 6:49 pm #50042
      DavidPrivett
      Participant
        • Offline

        i would not worry about those readings, I have a foton ft 504a and it is pretty much the same way. you could look at the tach and if it is idleing a little low turn up the idle speed a touch. Look in the operators manual I think the suggested idle rpm is listed( it is around 750 I think). I believe that 15/40 weight oil is the suggested one to use in it, might want to change to that if using something else.

        • May 17, 2023 at 12:03 pm #50043
          yocsr
          Participant
            • Offline

            I use 15w40 rotella oil. About 6 months ago the idiot light started coming on at idle so I installed a manual guage so I could see what was going on. I know if I have pressure I have lubrication but I don’t believe it used to be this way. My old Ford carries 45 psi warm or cold. I might step the idle up. The tach hasn’t worked for a while. I used to pull the dash periodically and clean the contacts to keep it working, but haven’t for a while. I set the throttle by sound.

        • May 17, 2023 at 6:40 pm #50044
          DavidPrivett
          Participant
            • Offline

            you say that the oil pressure relief is wide open , do you mean unrestricted ? I would think that the screw should be turned in some at least to put the spring under some tension. If you need me to I can turn mine in and count the rotations and give you a ballpark of where mine sits.

          • May 17, 2023 at 6:43 pm #50045
            DavidPrivett
            Participant
              • Offline

              oh I had a issue with my tach and it was the pickup on the bellhousing. if you want to see if your is dirty on the end look at it and screw by hand tenderly it till it contacts the flywheel and back out 1 -1/2 turns.

            • May 18, 2023 at 11:58 am #50046
              yocsr
              Participant
                • Offline

                I think the oil valve still has tension on the spring, but sure I’ll take the turn count. I have reset the flywheel sensor. I was losing contact on the plugs under the dash. I’m going to be out of town the next few days.

              • May 21, 2023 at 7:46 pm #50050
                DavidPrivett
                Participant
                  • Offline

                  well the oil pressure adjustment screw bottomed out at 2-1/2 turns , on a hot idle mine runs about 22 psi at 750 rpm as best as I can tell.

                • May 22, 2023 at 3:30 pm #50052
                  yocsr
                  Participant
                    • Offline

                    When I head back out there I’ll check it. Sounds like I’m probably ok. I just got concerned when the idiot light started coming on. That’s why I put the manual guage on so I could see what it was doing. Your probably right, I’ll bump the idle up just a hair. I don’t get any chatter like when I first start it up cold so it’s oiling.

                  • May 22, 2023 at 6:04 pm #50053
                    DavidPrivett
                    Participant
                      • Offline

                      heah, if the light came on I would have done the same thing by adding a manual gauge. cause a idiot light can not tell you much.

                  • Author
                    Posts
                  Viewing 6 reply threads
                  • You must be logged in to reply to this topic.