Louis Alletto

Forum Replies Created

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • September 5, 2019 at 6:18 pm in reply to: DOZER 3POINT ARMS WON\'T LOWER #49080
    Louis Alletto
    Participant
      • Offline

      Hi Bob, got an update. Brought the dozer home and with the help of my son, we removed the seat, floor plate and bevel gear cover. Gained access to the piston and pushed it back in. The lift arms on the three point were pretty stuck in position so we soaked them with WD 40. That may of been part of my problem why they would not go down, even with a couple hundred pounds of down pressure. Anyway we got it back together. My question is where are these stops you mentioned previously? Thanks

       

       

       

       

       

       

       

      August 10, 2019 at 12:38 pm in reply to: DOZER 3POINT ARMS WON\'T LOWER #49053
      Louis Alletto
      Participant
        • Offline

        Its raining down here so wont be able to start any disassembly, but did look it over and saw what you were talking about. Might have to wait till  I get it back home where i have air tools.

        August 9, 2019 at 6:23 pm in reply to: DOZER 3POINT ARMS WON\'T LOWER #49052
        Louis Alletto
        Participant
          • Offline

          Hi Bob i just arrived at the camp and will give that a try tomorrow. Luckily I have a parts manual down here,

          August 9, 2019 at 7:20 am in reply to: DOZER 3POINT ARMS WON\'T LOWER #49050
          Louis Alletto
          Participant
            • Offline

            Hi David thanks for the response. I know the knob your talking about.I have one on my John Deer tractor. I don’t recall seeing one one this Nortrac dozer. I will check tho. I may of even turned it and don”t remember.lol

          • Author
            Posts
          Viewing 4 posts - 1 through 4 (of 4 total)